:	Jun 30, 2004

.

Disconnect the battery ground cable.

.

Remove the torque converter flexplate.

.

Remove the cylinder block jackshaft plug.   Drift to release.

.

Using the special tool, remove the RH cassette jackshaft drive, sprocket bolt.   Remove and discard the Torx bolt.

.

Remove the camshaft drive cassette LH assembly.

.

Remove the oil pump drive gear.   Remove the bolt.   Remove the clamp.   Remove and discard the O-ring seal.

.

Remove the jackshaft thrust plate.   Remove the 2 Torx bolts.

.

Remove the jackshaft.   Collect the spacer.

.

Install the jackshaft.   Clean the component mating faces.   Install the jackshaft spacer.   Lubricate the components with clean engine oil.

.

:   The groove in the thrust plate must face the cylinder block. Install the jackshaft thrust plate.   Clean the component mating faces.   Lubricate the components with clean engine oil.   Tighten the Torx bolts to 10 Nm (7 lb.ft).

.

Install the oil pump drive gear.   Clean the components.   Lubricate the components with clean engine oil.   Install a new O-ring seal.   Install the clamp.   Tighten the bolt to 20 Nm (15 lb.ft).

.

Install the camshaft drive cassette LH assembly.

.

Using the special tool, install the RH cassette jackshaft drive, sprocket bolt.   Clean the component mating faces.   Using the special tool, tighten the new jackshaft sprocket bolt to 40 Nm (30 lb.ft), then a further 45 degrees.

.

Install the cylinder block jackshaft plug.   Clean the component mating faces.

.

Install the torque converter flexplate.

.

Connect the battery ground cable.